![]() ![]() ![]() $27 = 5.000 (Homing switch pull-off distance, millimeters) $26 = 250 (Homing switch debounce delay, milliseconds) $24 = 250.000 (Homing locate feed rate, mm/min) $11 = 0.010 (Junction deviation, millimeters) Error while processing response : An unexpected command was completed by the controller. Try increasing max travel, decreasing pull-off distance, or check wiring. Could not find limit switch within search distances. An error was detected while sending '$H': (ALARM:9) Homing fail. Wires have been checked everything seems to be hooked up properly per the manual. Hey i have a BobsCNC and am trying to figure out why when i HOME it does not move. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |